- My Portfolio (0)
WC installation system and bidet faucet
-
- Installation information
The installation height of the WC-Seat should be 40 cm
Water quantities
Operation of the bidet fitting with low-pressure displacement water heaters is not possible for the bidet fitting!
Requirements to ensure good functioning of this shower solution:
• Min. 0.5 bar flow pressure
• recommended flow pressure 1-5 bar
• Max. 10 bar operating pressure
• Test pressure 16 bar
If static pressure is greater than 5 bar, fit pressure reducer.
Avoid major pressure differences between cold and hot water supply.
• Flow rate at 3 bar flow pressure: approx. 10 l/min
• Hot water inlet max. 80°C
• Recommended: (energy saving) 60°C
General tips for installation
Please make sure that the water volume and the water pressure is adequate so as the waste is sufficiently be dimensioned. - Installation information
-
33603 Single-lever bidet mixer 1/2"
single hole installation
Add to My Portfolio
adjustable flow rate limiter
ball-joint mousseur
flexible connection hoses
pop-up waste set 1 1/4"
rapid installation system
covered lever fixing
GROHE SilkMove® 35 mm ceramic cartridge
GROHE StarLight® chrome finish
-
38528 Rapid SL for WC
flushing cistern GD 2
Add to My Portfolio
with small maintenance access
1.13 m installation height
for on-the-wall installations or studded walls
powder coated steel frame, self-supporting
for dry-cladding, completely pre-assembled
with fixed connections
for single or rail installation
quick adjustment, lockable
fixing material
TÜV approved
2 WC fixing bolts
fixing device for ceramic
distance of fixing bolts 180/230 mm
outlet bend ø 80 mm
depth adjustable
reducer Ø 80/100 mm
inlet and outlet connecting set
flushing cistern GD 2, 4.5 - 9 l
pneumatic discharge valve offering
3 modes of operation: dual flush or
start/stop or non-interruptible
water supply from left/right or back
low noise (group I acc. to
German Noise Specification)
DIN approved
insulated against condensation
½" water supply connection including integrated
angle valve and push fit flexible hose union
no tools required for the installation
of the inspection shaft incl. protection
during construction phase,
for vertical or horizontal use
without accessories for on-the-wall
installation
-
38732 Wall plate
for dual flush
Add to My Portfolio
for pneumatic discharge valve AV1
vertical and horizontal installation
156 x 197 mm
ABS
GROHE EcoJoy®technology for
less water and perfect flow
GROHE StarLight® chrome finish
